Chevy Trax Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello All, I own a 2015 Trax. It keeps throwing up code to replace O2 sensor. I've replaced both sensors and reset the codes. It will run well for a few days and then start idling rough and going dead sometimes. I have taken it to two different shops, and the dealer and all have replaced sensors and reset codes, and we end up with the same results. I thought, what the **** I can guess as good as them so I purchased an Innova code reader and started over. So far I've replaced both O2 sensors and I think it was called the MAP sensor. It ran good for maybe two weeks and started running rough again. I reset them again and seems to be ok for now, but I know it will happen again. Since these sensors are new. I've got another problem and I'm not sure where to begin. Can any of you help me? thank you
 

·
Administrator
Joined
·
2,769 Posts
Make sure you don't have a bad cell in your battery.
 
  • Like
Reactions: c502cid
1 - 3 of 3 Posts
Top